JVC KD-AV7010 Service Manual page 12

3.1.6 Removing the main board
(See Figs.12 and 13)
• Prior to performing the following procedures, remove the de-
tach panel assembly, front panel assembly, top drive unit and
DVD mechanism assembly.
(1) From the rear side of the main body, remove the four
screws K attaching the rear bracket. (See Fig.12.)
(2) From the top side of the main body, remove the two screws
M attaching the mechanism bracket on the bottom chassis
assembly. (See Fig.13.)
(3) Remove the five screws N and two screws P attaching the
main board. (See Fig.13.)
(4) Take out the main board from the bottom chassis assem-
bly.
Reference:
When attaching the main board on the bottom chassis assem-
bly, align the projections b of the bottom chassis assembly in
the hole of the main board. (See Fig.13.)
3.1.7 Removing the front board
(See Fig.14)
• Prior to performing the following procedures, remove the de-
tach panel assembly and front panel assembly.
(1) From the inside of the front panel assembly, remove the
three screws Q and screw Q' attaching the front board.
(2) Take out the lock lever assembly from the front panel as-
sembly.
(3) Bend the hooks c in the direction of the arrow.
(4) Release the front board from the sections d and take out
the front board from the front panel assembly.
Reference:
When attaching the screw Q', attach the lock lever assembly
with it.
1-12 (No.MA184)
Rear bracket
Fig.12
P N
b
N
M
Mechanism bracket
Fig.13
Lock lever assembly
d
c
Q'
Front board
Fig.14
K
Main board
b
N
M
P
b
Bottom chassis assembly
Front panel assembly
c
d
Q