Troubleshooting Guide; Replacement Parts; Product Registration - Ninja CFN600 Series Owner's Manual

Espresso & coffee barista system
Table of Contents

Advertisement

TROUBLESHOOTING GUIDE

Can't select Keep Warm.
• Keep Warm can be turned on manually by pressing WARM while in Grounds mode with Classic or
Rich, and any Carafe size selected. If brewing a smaller size into the carafe, after the brew has finished
select Classic or Rich and turn the dial to any carafe size, then press WARM.
There's sediment in my coffee.
• If using a permanent filter, this may be due to using finely ground coffee.
• To reduce the amount of sediment in the brewed coffee, use a slightly coarser grind or use a paper filter.
NOTE: DO NOT use a paper filter in conjunction with a permanent filter, as water and/or coffee can
back up and clog the filter basket.
Over Ice Brew is not cold.
• Ensure your cup, travel mug, or carafe is filled all the way to the top with ice cubes before brewing.
Brewer will brew at elevated temperatures to lock in the best flavor, then the ice will cool the brewed
coffee to the perfect temperature. Lower volumes of coffee will be brewed to account for some ice melt.
Coffee is too weak.
• For stronger coffee, use the Rich brew setting. For an even bolder flavor, you can add more coffee
grounds to the filter.
Brew cycle is too slow.
• The brew time will vary based on size and brew style. Full carafe sizes and Rich brews will take longer
to brew than single-serve and classic brews. The progress bar on the control panel will indicate brew
status.
Cup or travel mug overflowed.
• Refer to the Approximate Brew Volumes chart on page 10.
Brew basket overflowed.
• The bottom of the brew basket may be clogged. This can happen with finely ground coffee or too
many coffee grounds in the filter. Medium-grind coffee is recommended.
• Using both the permanent filter and a paper filter can cause grounds to clog and water to back up in
the brew basket. Use only the permanent filter or a paper filter.
• Decaf coffee grounds absorb water differently, so use fewer scoops when using decaf.
There is water left in the reservoir.
• When the reservoir is filled to a specific size and then that size is brewed, there will be some water left
in the reservoir. This is normal to ensure the reservoir does not run dry for the best performance of the
pump and brew system.
Brewer is leaking.
• After removing the water reservoir, there may be a small amount of water in the reservoir valve. This
can be easily removed with a dry cloth.
• If the leak is coming from above the brew basket, refer to "Brew basket overflowed." above.
• If the leaking is coming from below the brew basket, close the drip stop. Refer to page 12
for more information.
• If the leaking is coming from the capsule side, ensure the adjustable cup tray is in place to catch any
excess drips.
• If the leak is coming from the bottom of the brewer, call Customer Service at
1-877-646-5288.
Intelligent Clean Cycle Indicator is illuminating orange.
• Run a clean cycle. If you have recently completed a clean cycle, you may need to run another cycle to
remove additional mineral buildup that occurs naturally over time and is common in hard-water areas.
Make sure you are using vinegar or a descaling solution and follow the cleaning instructions on pages
13 and 14.
Coffee is not hot enough.
• If brewing into the carafe, ensure Keep Warm is on. The Intelligent Warming Plate temperature can be
adjusted between Low, Medium, and High (see Time & Temperature Adjustment on Page 11.)
• Adding cold milk or creamer to coffee will effect the temperature.
• We recommend prewarming the cup with hot water before brewing.
Capsule doesn't fit / Capsule is getting crushed
• This brewer is only compatible with Original Capsules.
• Ensure the capsule is being inserted in the correct orientation as shown on the unit
• The Capsule Bin may be full. See page 13 for how to remove Capsule Bin.
Brewer is loud
• This brewer uses a high pressure pump in order to evenly saturate and extract flavor of the capsules.
Lever not closing completely
• Empty the Capsule Bin. Ensure all used capsules are removed and no capsule is blocked. See page 13.
16 1-877-646-5288
Coffee is splattering.
• Some splatter is normal. Use the cup tray when possible to reduce the distance between the cup and
the coffee outlet.
Water reservoir is unstable.
• Ensure the water reservoir is installed securely on the hook.
CLOCK DISPLAY MESSAGES:
End
• The brew cycle is complete.
PrE
• While brewing capsules, once START BREW has been pressed the clock display may show "PrE".
This indicates the brewer is preheating and the brew will automatically start once the brewer is up to
temperature.
Add Wtr
• Ensure water is in the reservoir. If the reservoir is empty, add fresh water to the reservoir and then
press START BREW to resume the brew.
• If the reservoir is filled with water, remove and reseat the reservoir and then press START BREW to
resume the brew.
• If brewing capsules, try removing the capsule and brewing again. If the issue persists, run a clean
cycle on the capsule side following the instructions on page 14 and 15.
• If brewing grounds and the issue persists, contact Customer Service at 1-877-646-5288.
CLn
• The system has detected that a clean cycle needs be run immediately to remove calcium scale
buildup in the heater. See 'Cleaning & Descaling Your Brewing System' for instructions.
StOP
• A brew cycle was cancelled.
ERROR MESSAGES:
Er
• If the clock displays "Er" and then a number (ex. "Er 03"), contact Customer Service at 1-877-646-5288.

PRODUCT REGISTRATION

Please visit registeryourninja.com or call 1-877-646-5288 to register your new Ninja® product within ten
(10) days of purchase. You will be asked to provide the store name, date of purchase, and model number
along with your name and address.
The registration will enable us to contact you in the unlikely event of a product safety notification. By
registering, you acknowledge you have read and understood the instructions for use and warnings set
forth in the accompanying instructions.

REPLACEMENT PARTS

To order additional parts and accessories, visit ninjaaccessories.com or contact Customer Service at
1-877-646-5288.
17
ninjakitchen.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cfn601Cfn602

Table of Contents