Operation Mode - Clarion VRX756VD Owner's Manual & Installation Manual

Basic Operations
Adjusting the GENERAL
Setting the BEEP
∗ The sound heard when you make operations is
called "beep". The unit can be set up so that it
does not produce this beep sound.
∗ The factory default setting is "BEEP ON".
1. When the panel is open, press the [ADJ]
button to select the ADJUST MODE menu.
2. Touch the [GENERAL] key.
Touch the [BEEP] key to select "ON" and
"OFF".
3. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
Setting the button illumination
∗ The factory default setting is "GREEN" (green).
1. When the panel is open, press the [ADJ]
button to select the ADJUST MODE menu.
2. Touch the [GENERAL] key.
3. Touch the [KEY ILLUMI] key to select "RED"
(red) or "GREEN" (green).
4. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
Clock Adjustment
1. When the panel is open, press the [ADJ]
button to select the ADJUST MODE menu.
2. Touch the [GENERAL] key.
Touch the [CLOCK] key to adjust the time.
3. Touch the [w], [z], [a.m] or [p.m] key to
adjust the time, then touch the [SET] key.
∗ The time is displayed in 12-hour format.
4. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
Setting the Auto Panel
When you remove or attach the DCP, you can
set the liquid crystal panel automatically housing
or opening.
∗ The factory default setting is "ON".
1. Press the [ADJ] button to select the ADJUST
MODE menu.
2. Touch the [GENERAL] key.
Touch the [AUTO PANEL] key to set "ON",
"OFF" or "CLOSE".
28
VRX756VD
ON: The liquid crystal panel houses
automatically after removing the
DCP.
And the liquid crystal panel open
automatically after attaching the
DCP.
OFF: Normal operation.
CLOSE: The liquid crystal panel houses
automatically after removing the
DCP.
3. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
Switching CONNECT(connect)
Make the following settings when an external
device is connected to the Visual terminal.
NAVI: when a navigation system is
connected
∗ When a navigation system is
connected, use the monitor lock
function. Locking the monitor locks
the screen size in F.WIDE mode (full
wide) and the VTR system to NTSC.
OTHERS: for external devices other than a
navigation system
NONE: when no external devices are
connected
∗ The factory default setting is "NONE".
1. When the panel is open, press the [ADJ]
button to display the ADJUST MODE menu.
2. Touch the [GENERAL] key.
Touch the [CONNECT] key to select "NAVI"
or "OTHERS" or "NONE".
3. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
Time setting in air conditioner

operation mode

This setting can be used to adjust the time the
panel stays in the horizontal position when in
the air conditioner operation mode.
∗ The factory default setting is "10s".
1. Press the [ADJ] button.
2. Touch the [GENERAL] key.
3. Touch the [HVAC MODE] key to set to "5s,"
"10s," or "30s."
4. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.