Troubleshooting - Panasonic F-GPT01R Installation And Operating Instructions Manual

MAINTENANCE
Filter <about once every 2 weeks>
Remove the filter from the product (How
1
to remove the filter →Page 6).
Wash off the dust with water.
2
Let the filter air dry after washing.
3
Stubborn dirt
When the dirt is difficult to remove, dampen a soft
●
sponge with a small amount of neutral kitchen
detergent to clean it. Then, rinse the detergent off
and let the filter air dry in a cool place.
Notice
The filter is fragile, so please do not press or wipe
●
it with too much force when cleaning. (Otherwise,
the inhaled dust may enter the product from the
damaged part, thus resulting in malfunction.)
Notice
Do not operate the product with the filter removed.
●
(Otherwise, the inhaled dust may enter the product,
thus resulting in malfunction.)

TROUBLESHOOTING

If a problem is encountered, please investigate it by going through the following items.
If the problem still persists, be sure to unplug the USB power cord from the main unit.
Please contact the dealer for repair.
Possible situation
The product
does not work.
An odor is smelt.
A "jee" sound is
from the
emission outlet
Operation stops.
The operation
indicator is
blinking.
The operation
indicator goes
dim.
The air volume
becomes low or
sometimes high
and sometimes
8
low.
Is the USB power cord connected properly and securely?
●
Is there any dirt on the product or filter?
●
Please clean it. (Page 7 ~ 8)
→
When nanoe X is generated, you may smell a slight ozone
®
●
odor, which is not harmful to your health. (Page 9)
There is a slight sound when nanoe
●
on the environment and operation mode, the sound may be a
bit loud or inaudible but it is not abnormal phenomena.
Is the USB plug connected properly?
●
Please insert the USB plug into the USB socket properly. (Page 7)
→
The circuit fails.
●
Be sure to unplug the USB power cord from the main unit.
→
Please contact the dealer for repair.
Is a power supply with the maximum output current lower than
●
1.5 A used?
Please use a power supply with the maximum output current
→
of 1.5 A or above.
Wipe the outer surface with a
wrung out soft cloth. Wiping
with a hard cloth may damage
the surface.
When idle for a long time
Unplug the USB power cord
1
from the main unit.
2 Perform regular maintenance
and care.
Wrap the product with a plastic
3
bag and store it in a
low-humidity place.
Please confirm the following
X is generated. Depends
®
The product