How To Use Electric Home Shower; How To Use - Panasonic DH-4UDP1 Operating And Installation Instructions

HOW TO USE ELECTRIC HOME SHOWER

HOW TO USE

1. Turn "On" the Main Water Valve.
2. Switch "ON" the Miniature Circuit Breaker (MCB) and ON/OFF DP (double pole) Switch.
3. Push up the ELB Reset Lever if it is down.
4. Turn the Water Volume Knob clockwise.
• Turning it clockwise increases the volume of water thus decrease
the water temperature.
• Turning it anticlockwise decreases the volume of water thus increase
the water temperature.
5. Press the Push On-Off Button.
a) Water will fl ow out of the Shower Head.
b) Simultaneously,
DH-4UDP1 & DH-4UD1 - LCD Display illuminates and display Temperature Indicator,
DH-4UP1 & DH-4US1
c) To stop the water fl ow, press the Push On-Off Button again.
d) This Lever control both water and electricity supply to the set.
CAUTION
6. Select the preferred shower by turn the Shower Select Lever.
Shower Select Lever
Wide Shower
Normal Shower
Spot Shower
7. Shower Head can be set at various positions.
a) Loosen Shower Hanger Knob and Shower Hanger can be adjusted higher or
lower position.
Tighten Shower Hanger Knob.
b) Loosen Shower Hanger Knob and Shower Hanger can be adjusted to the left or
right position.
Tighten Shower Hanger Knob.
c) The angle of Shower Head can be adjusted by moving the Shower Head upward
and downward.
8. Temperature setting.
DH-4UP1 & DH-4US1
a) The shower temperature can be gradually controlled by setting the Power Control Knob to
the desired position.
b) If you turn the Power Control Knob clockwise the shower temperature will go up, reaching the
highest temperature at "High".
c) If the Power Control Knob is at "Off" position, the water temperature will remain at inlet
temperature.
d) In case of continuous usage at high temperature setting, water temperature will increase and it
may cause the control device in the set to activate temporarily resulting water temperature to drop.
EN6
Clock & Shower Head Indicator.
(When the power ON, the temperature becomes 38°C)
- The ELB light will be light up.
Press Push On-Off Button before and after each shower.
Press the Push On-Off Button only. Do not pull.
Do not turn "On" and "Off" the Main Water Valve to operate the shower Unit to
avoid any possible damage.
For DH-4UDP1 & DH-4UP1 model only
To ensure Pump reliability, Push On-Off Button must be pressed before and
after each shower.
Do not pull the Push On-Off Button, press only.
ELB: ON condition ELB: OFF condition
Make sure push at the
center of Push On-Off
Button only.
Note:
When stop the water fl ow or
change water shower selection
from Wide Shower to Spot Shower,
some water will continue to drip
from Shower Head for less than
2 minutes. This is normal due to
some water remain in the
Shower Head and no abnormality
to the Unit.
(a) (b) (c)
ELB
Off High
Power Control