How To Install - Panasonic DH-4UDP1 Operating And Installation Instructions

HOW TO INSTALL

WARNING
During installation process make sure
electric and water supply is turn "OFF".
1. Where to install the Unit.
• Be sure to install the Unit on the wall as illustrated
in Figure 1 (vertical condition only).
• Do not install the Unit away from wall surface as
shown in Figure 2.
• The Unit must be installed at 1.5 m ~ 1.7 m
above the fl oor.
2. How to remove the Front Plate.
DH-4UDP1 & DH-4UD1
Remove the screw at the bottom of the Unit.
Remove the Front Plate by lifting up the bottom side and then
unhook the top side.
DH-4UP1 & DH-4US1
Make sure the Power Control Knob is
at "Off" condition.
Remove the Screw at the bottom of
the Unit.
Lift up the Power Control Knob to
make it free (Power Control Knob is
attached to "VR Shaft" inside the Unit).
Make sure the Power Control Knob is
not detached from the Front Plate.
Remove the Front Plate by lifting up the bottom side and then unhook the top side.
3. How to fi x Electric Home Shower.
The distance of the Unit should be more than
250 mm at right and left of the wall.
Make 4 holes in the wall using a drill. The location
of the hole position as shown in the INSTALLATION
TEMPLATE provided.
Drive a Wall Plug into the hole.
Lead the Flexible Cord to the set thru Portion 1 or 2 as shown below for electric wiring process.
Portion 1:
Flexible Cord Entry Point
CAUTION
EN12
Cold Water
Tank
Service Valve
Safe
Pump
U-Memory
- +
U-Mode
Pump Set
U-Memory
1 2 3
* Maximum total length
1.5 m ~
of feeding pipe should
1.7 m
be below 10 meter.
* The feeding pipe
should be 1/2 inch.
For DH-4UDP1 & DH-4UP1
ELB
Off High
Power Control
Power Control Knob
113 mm
Wall
Screw
Screw
170 mm
250 mm
minimum
Figure 1
Portion 2:
Flexible Cord must enter the Unit thru designated point only
(do not make additional holes).
Main Pipe Rising Level
33 ft (10 meter) maximum
recommended height between
bottom of cold water tank
and top of Home Shower
Unit.
1.5 m ~
1.7 m
For DH-4UD1 & DH-4US1
Lift up Front Plate
Screw
Note:
Power Control Knob attached to Front Plate.
Lift up
Screw
Wall
Ø6 mm
250 mm
minimum
ELB
Figure 1
Off High
Power Control
Figure 2
Front Plate
Power Control Knob
25 mm
Wall Plug