English - Kenwood JK350 Series Manual

safety
Avoid contact with steam coming
out of the spout area when pouring
and out of the lid when refilling.
Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the kettle
down. If you don't need so much
cord, shorten it. See 'before
plugging in' below. Cordless models:
push excess cord inside the
powerbase.
Never overfill - boiling water may
splash out.
Never put the kettle, powerbase,
cord or plug in liquid.
Do not use if there is any damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired: see
'service'.
This kettle is not intended for use by
young children or infirm persons
without supervision.
Young children should be supervised
to ensure they do not play with the
appliance.
Caution: Do not operate the kettle
on an inclined surface.
Cordless models: only use the
powerbase supplied and keep it
clean and dry.
Make sure the lid is secure before
switching the kettle on.
Warning: Do not open the lid while
the water is boiling.
Take care when opening the lid -
droplets of hot water may be
ejected.
Make sure the kettle is switched off
before lifting or pouring.
Cordless models: remove from the
base before filling or pouring.
Corded models: unplug the cord
from the kettle before filling or
pouring.
Never put the kettle near or on
cooker hot plates or gas burners.
This kettle is for boiling water only.

English

This kettle is for domestic use only.
Failure to observe these cautions
may result in damage to the kettle.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
This kettle complies with European
Economic Community Directive
89/336/EEC.
before using for the first time
Remove all packaging and any
labels.
Fill to 'MAX', boil, then pour the
water away.
key
lid catch
water level gauge
on/off switch with neon
powerbase (JK750 series only)
with multiposition cord exits
compartment for excess cord
scale filter
to use your jug kettle
1 Fill it through the spout or lid. To
open the lid, pull back the catch.
The water level must be between
'MAX' and 'MIN'.
Be economical: do not boil more
water than you need.
To improve the quality of your drinks
always use fresh water.
Empty the kettle after each use.
2 Check the lid is closed.
3 Plug in and switch on. The neon will
come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
Your kettle is fitted with a scale filter
to hold back limescale particles.
If you find drops of water under your
kettle, don't worry - it is just
condensation.
2