Luxen Home WHF733 Instruction Manual

Luxen Home WHF733 Instruction Manual

Cement/resin whiskey barrels and water pump outdoor patio fountain with led light

Advertisement

Product Name:
SKU #:
Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.

CARTON CONTENTS:

Description
01 Fountain
02 Pump w/ Adaptor
03 Faucet Spout w/ tube
04 Handle
05 Bolt
06 Nut
Tools required for assembly: No tools required for assembly.

Assembly Instructions:

1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Place the fountain on a flat, level surface. Insert handle and place blot through the holes and screw in nut.
(①)
4. From the opening at the back of the fountain base, insert the water supply tube into the pump outlet. Place
the pump upright in the basin and draw the pump power cord out of the fountain back. (②)
5. Add clean water into the basin. The water level should be approximately 1.18in (30mm) lower than the edge
of the basin. The pump will be submerged in the water. (③)
6. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin
to function as intended. (
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
8. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
9. Check the area around your fountain on a regular basis to ensure that there is no leakage.
10. Please refresh the fountain with water each week to ensure it in good condition.
11. Do not add any harmful chemicals to the water as it may alter the paint finish.
Cement/Resin Whiskey Barrels and Water Pump Outdoor Patio Fountain with LED Light
WHF733
Accessories standards and type
PT350-LV
)
Contact: sales@winsomehouse.com
Please save this manual for future reference.
Quantity
1
1
1
1
1
1
Instruction Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WHF733 and is the answer not in the manual?

Questions and answers

Summary of Contents for Luxen Home WHF733

  • Page 1 Product Name: SKU #: WHF733 Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest standards of safety and quality. PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY. Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged parts.
  • Page 2 Please save this manual for future reference. Cement/Resin Whiskey Barrels and Water Pump Outdoor Patio Fountain with LED Light Product Name: SKU #: WHF733 Note: The above diagram is for illustrative purposes only. Pump Instructions: Special Warnings and Cautions: CAUTION: •...
  • Page 3 Cement/Resin Whiskey Barrels and Water Pump Outdoor Patio Fountain with LED Light Product Name: SKU #: WHF733 • Check the water level regularly to ensure the pump is completely submerged during operation. The pump should be fully submerged during operation. Do not add water while operating the product. Always disconnect the pump from the power source before adding water.
  • Page 4 Cement/Resin Whiskey Barrels and Water Pump Outdoor Patio Fountain with LED Light Product Name: SKU #: WHF733 CARE & MAINTENANCE: 1. Keep the water clean – clean water will prolong the useful life of your pump. 2. Use a pre-filter on your pump if available.

Table of Contents