Table of Contents
Advertisement
Important Safeguards
When using electrical appliances, in
order to reduce the risk of fire, electric
shock and/or injury to persons, basic
safety precautions should always be
followed, including:
For Your Safety
Read all instructions carefully, even if you feel
you are quite familiar with the appliance.
Electrical safety and cord handling
•
Voltage: Make sure your outlet voltage and
circuit frequency correspond to the voltage
stated on the appliance rating label. If it does
not match, contact our after sales support line
and do not use the appliance.
•
Connection: Insert the plug properly into an
earthed mains socket. Make sure the socket
is within easy reach so the plug can easily be
removed if necessary.
•
Electrical circuit: To avoid an electrical circuit
overload do not use a high wattage appliance
on the same circuit with the Steam Air Fryer.
•
Do not immerse: To protect against electric
shock, do not immerse the cord, plug or the
electric base in water or other liquid. If the
base is accidentally immersed, immediately
unplug the power plug, dry the appliance and
have it checked by qualified service personnel.
•
Protect from moisture: Do not expose the
electrical connections to water.
Do not use the appliance, or touch the plug,
with wet or damp hands, on a damp floor or
when the electric base is wet.
•
Power cord: A short power supply cord is
provided to reduce the hazards resulting
from becoming entangled in or tripping over
a longer cord. However, if an extension cord
must be used, make sure its marked electrical
rating is the same as the product. Arrange the
extended cord so it will not drape over the
table or benchtop where it can be pulled on or
tripped over accidentally. Do not kink, bend,
squash, strain or damage the power cord and
protect it from sharp edges and heat. Do not
let the cord hang over the edge of a table or
benchtop, or touch hot surfaces.
•
Damage: Check the power cord regularly for
visible damage. If it is damaged, it must be
replaced by the manufacturer, its authorised
service centres or similarly qualified personnel
in order to avoid any hazards. Do not pick up
or operate an appliance with a damaged cord
or plug, or after the appliance malfunctions or
has been dropped or damaged in any manner.
In case of damage, call our after sales support
line for advice on repair or return of the
damaged product.
•
Unattended: Do not leave the appliance
unattended when plugged in.
•
After use: Unplug the appliance after use.
Wait until it has cooled completely before
attempting to move or clean it.
•
Disconnect: Always unplug the power cord
when the appliance is not in use. When
unplugging the appliance, grip by the plug, do
not pull by the cord.
•
RCD: Unless your home is already fitted with
a residual current device (safety switch), we
recommend installing an RCD with a rated
residual operating current not exceeding
30mA to provide additional safety protection
when using electrical appliances. See your
electrician for professional advice.
CAUTION: Hot Surfaces & Steam !
The Steam Air Fryer and accessories will become
very hot during use. Do not come into contact
with heated parts while or after using the Steam
Air Fryer! Only touch the handles and control
knobs while the Steam Air Fryer is in operation or
immediately after it has been switched off. The
appliance needs approximately 30 minutes to
cool down. Wait until the Steam Air Fryer has
cooled down and make sure all components
are clean and dry fully before it is transported,
cleaned or stored away. Use oven gloves if
necessary when handling the hot accessories.
Remove the basket! Also be careful of hot steam
and air when you remove the basket from the
appliance.
Free space: Do not place the appliance against a
wall or against other appliances. Hot air up to 160
Degrees and hot steam expels through the
rear vent of the appliance. Leave at least 30cm
clearance around the entire appliance, including
directly above it. Additional care should be taking
when placing appliances on bench top surfaces
or near splash backs where such materials
(Acrylics, timber etc.), do not have the high heat
resistant properties, so advise to place them on
2
Advertisement
Table of Contents
