Making A Basic Measurement - Agilent Technologies N9340A User Manual

Making a Basic Measurement

This section provides information on basic analyzer
operations. It assumes that you are familiar with
the front and top panel buttons and keys, and dis-
play annotations of your analyzer. If you are not,
please refer to
and
Annotations"
For more information on making measurements,
please refer to
page
Entering Data
When setting measurement parameters, there are
several ways to enter or modify active function
values:
1 Using the Front Panel Knob
Increases or decreases the current parameter value.
2 Using the Arrow Keys
Increases or decreases the current value by the
step unit defined.
Press [FREQ] > {CF Step} to set the frequency by an
auto- coupled step (Step = Span/10, when {CF Step}
mode is set to Auto).
3 Using the Numeric Keypad
Enters a specific value. Then press a terminator
key (either a specified unit softkey or [ENTER]) to
confirm input.
4 Using the Unit Softkeys
Terminates a parameter value which requires a
unit input.
5 Using the Enter Key
Terminates an entry or confirms a selection.
N9340A User's Guide
"Front Panel Overview"
"Top Panel Overview" on page
on page 6
"Making Measurements" on
41".
Getting Started
on page 4
5, and "Display
1
21