Select the Mode
1 To select the mode, press:
Select Single or
Continuous
Sweeps
2 Press the left-side Trg,Cal softkey.
3 Select one of the following sweep states:
• Press SINGLE to select single sweeps. Each additional press of this softkey
• Press CONT STOP CONT to select continuous sweeps.
• Press CONT STOP STOP to stop the sweeps.
Select Trigger
Source
4 Press the left-side Setup softkey.
5 Press CH2.
Getting Started
Steps for Setting Up Eye-Diagram Analysis
the instruments' front panels, follow the instructions shown. Otherwise,
proceed with "If you have not already connect the cables to the instruments'
front panels, follow the instructions shown. Otherwise, proceed with "If you
have not already connect the cables to the instruments' front panels, follow the
instructions shown. Otherwise, proceed with ." on page 1-21." on page 1-21."
on page 1-22." on page
Step 4. Set Up the Measurement Conditions
Setup, diagram, EYE, EYELINE, or PATTERN
triggers another sweep.
• If the pattern generator's CLOCK OUT signal is connected to the RF INPUT
2 connector, press CLK OUT.
• If the pattern generator's TRIGGER OUT signal is connected to the RF IN-
PUT 2 connector, press TRG OUT.
1-22.