Raider RD-PUSG13 User Manual page 10

10
www.raider.bg
Използване на пистолета:
1. Connect the gun to a compressor using a suitable hose
2. Make sure the nozzle is well connected to the gun
3. Point the gun to the desired surface
WARNING: Be careful with compressed air. Do not direct air against people or animals.
WARNING: wear eye protection - an overwhelming jet can eject particles to your face.
POLYURETHAN PISTOL SETUP
The desired width, foam release volume and fine tuning can be easily adjusted by the appropriate
regulators
III. SUPPORT
POLYURETHAN PISTOL MAINTENANCE
1. Incomplete cleaning will cause uneven foam dispersion or particle discharge.
2. Clean the remaining sections of the gun with a brush and solvent and with a soft cloth
3. Remove the nozzle
WARNING
Never use a wire brush or other hard objects to clean the nozzle. Never immerse the gun com-
pletely in solvent. When assembling clean parts, be careful not to get dust
WARNING: Never use corrosive detergents
SYMPTOM
uneven spraying
or "spitting"
the stream is arch-like
the jet is unsmooth
the jet is narrowed in the
center
the width of the jet is
insufficient
CAUSE
The polyurethane is over
Dry or worn needle
Loose or worn nozzle
Worn or loose nozzle
Material drenched at the outlet
of the nozzle
Material drenched at the outlet
of the air ducts
The nozzle is dirty or worn
The amount of foam is insuf-
ficient
the air pressure is too high
foam quality
the air pressure is too low
REMOVING
Replace the vial
Lubricate the nozzle and the flywheel
or replace them with new ones
Tighten or replace the nozzle
Tighten or replace the nozzle
Remove the material through the
nozzle, but DO NOT use metal tools
to clean it
clean the air nozzles
clean or replace the nozzle
Check the quality of the foam
reduce air pressure
Check the quality of the foam
increase air pressure