Table of Contents
Advertisement
Mounting Condensing Unit.
Mounting base should be concrete or steel
sufficient to support between 2 to 5 times the
weight of condensing unit.
Condensing units must be mounted using
Spring Mounted Compressor.
Semi-hermetic compressor unit use the mounting assembly shown in Figure 11, the shipping spacer
is to be in place during shipment to insure maximum support for the compressor body during
transit.
Before the unit is put in operation, the shipping spacer should be removed and discarded.
Before operating the unit, it is necessary to follow these steps.
1.
Remove the upper nuts and washers.
2.
Remove and discard the shipping spacers.
3.
Install the rubber spacer. (rubber spacer tied to compressor.)
4.
Replace the upper mounting nuts and washers.
5.
Allow 1/16" between the upper nut and the rubber spacer as Figure 11.
Figure 11. Spring Mount.
System Operation.
pads to avoid vibration or shifting.
The anchor bolts should be used to fix the unit
and tightened with spring washer and nuts.
13
Advertisement
Table of Contents
Troubleshooting
