Table of Contents
Advertisement
Install or Change Batteries
1.
Loosen the six (6) screws on the device cover, using a #1 or
smaller Phillips screwdriver.
NOTICE: The screws are intentionally retained to the cover,
when loosened, to prevent losing them.
2.
Install (3) fully charged AA batteries in the device. Be sure to
orient the batteries properly so +/- matches indicators shown
on battery case.
3.
Replace the cover making sure the perimeter seal (O-ring) is
in place, then securely tighten the six (6) screws. Be sure not
to over-tighten screws.
4.
Press & hold button at least 3 seconds until light flashes blue
3 times indicating the device is ON.
5.
Press & hold button at least 3 seconds again until light flashes
red 3 times indicating the device is OFF.
NOTICE: If the device is ON, it will record any movement
such as walking with the device in hand or installing the
device to the compressor so be sure to keep it off until
installed on the desired compressor and ready to use.
6.
Operating temperature range of the device depends on AA
batteries (32° F / 0° C to 104° F / 40°C).
4
Advertisement
Table of Contents
