Step-By-Step Installation Guide; Placement Of The Mounting Plate; Removing The Mounting Plate; Finding The Wall Studs - Samsung ME17R7011ES/AC Installation Instructions Manual

Step-by-step installation guide

1. PLACEMENT OF THE MOUNTING PLATE

A. REMOVING THE
MICROWAVE OVEN FROM
THE CARTON/REMOVING
THE MOUNTING PLATE
1
. Remove the installation instructions, Exhaust
adaptor, filters, glass tray and the small hardware
bag. Do not remove the Styrofoam protecting the
front of the oven.
2
. Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in the
Styrofoam.
3
. Pull the carton up and off the oven.
4
. Remove and properly discard plastic bags.
Screws
Mounting Plate
5
. Remove the 2 screws from the mounting plate. This
plate will be used as the rear wall template and for
mounting.
NOTE: You will have to reuse two screws in original
location of outcase after removing mounting plate.
DE68-03587B-EN.indd 8
Screws
8
B. FINDING THE WALL STUDS
1
. Find the studs, using one of the following methods:
A. Stud finder-a magnetic device which locates
nails.
OR
B. Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate a
stud location.
2
. After locating the stud(s), find the center by probing
the wall with a small nail to find the edges of the
stud. Then place a mark halfway between the
edges. The center of any adjacent studs should be
16" or 24" from this mark.
3
. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO AT
LEAST ONE WALL STUD.
2008-12-09 �� 4:13:05