Step-By-Step Installation Guide; Placement Of The Mounting Plate; Removing The Microwave Oven From The Carton/Removing The Mounting Plate; Finding The Wall Studs - Samsung ME19R7041FW/AC Installation Instructions Manual

Step-by-step installation guide

1. PLACEMENT OF THE MOUNTING PLATE

A. REMOVING THE MICROWAVE OVEN
FROM THE CARTON/REMOVING THE
MOUNTING PLATE
1. Remove the installation instructions, Exhaust
adaptor, filters, glass tray, and the small hardware
bag. Do not remove the Styrofoam protecting the
front of the oven.
2. Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in the
Styrofoam.
Styrofoam Styrofoam
3. Pull the carton up and off the oven.
4. Remove and properly discard plastic bags.
Screws
Screws
Mounting Plate Mounting Plate
5. Remove the 2 screws from the mounting plate. This
plate will be used as the rear wall template and for
mounting.
NOTE: You will have to reuse two screws in original
loction of outcase after removing mounting plate.
SMH1927_XAC_DE68-04108D-02_EN+CFR.indb 8 SMH1927_XAC_DE68-04108D-02_EN+CFR.indb 8
Carton
Carton
Screws
Screws
B. FINDING THE WALL STUDS
Wall Studs
Wall Studs
Center
Center
1. Find the studs using one of the following methods:
A. Stud finder–a magnetic device which locates nails.
B. Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate a
stud location.
2. After locating the stud(s), find the stud's center by
probing the wall with a small nail to find the edges of
the stud. Then, place a mark halfway between the
edges. The center of any adjacent studs should be
16˝ or 24˝ from this mark.
3. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO AT
LEAST ONE WALL STUD.
8
OR
2022-01-20 오전 10:26:12 2022-01-20 오전 10:26:12