20
EN
Operation Switch
A
M
START/STOP Button
Power Switch
Tally lamp
(lights while
recording is
in progress)
RECORDING
Lock Button
Power lamp
Basic Recording For Video (cont.)
Shooting While Watching The LCD Monitor
Before the following steps, perform step 1 (
2
ENTER RECORD–STANDBY MODE
Make sure the viewfinder is pushed back in. Set the
Operation Switch to "
Power Switch to "
Lock Button.
Open the LCD monitor fully.
•The lens cover opens, the power lamp lights and the
camcorder enters the Record-Standby mode.
•The scene you are aimed at appears in the LCD
monitor, with the word "PAUSE" superimposed
upon it.
3
START SHOOTING
Tilt the LCD monitor upward/downward for best
viewability (
pg. 21) and press START/STOP.
•"
" appears in the LCD monitor while recording
is in progress.
4
STOP RECORDING
Press START/STOP again to stop recording.
•The camcorder re-enters the Record-Standby mode.
NOTES:
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
(
pg. 18).
To turn the tally lamp off during recording, refer to
pgs. 34 – 39.
For other notes, refer to pg. 19.
pg. 18).
" or "
". Then, set the
" while pressing down the