Table of Contents
Advertisement
Using your handheld vacuum
Note:
For household indoor use only.
Charging
• Insert the charger into the Charging Port of your handheld vacuum.
The LED Light will flash blue when charging. Once fully charged, the
LED Light will turn off.
Note:
The vacuum takes up to 4 hours to fully charge.
• The LED Light will flash red when your handheld vacuum is
low on battery.
• It is recommended that you charge your vacuum after each
use, to maintain maximum performance.
Note:
As a safety precaution, the vacuum cannot be switched on while
charging.
Storage
Your handheld vacuum can be wall-mounted using the wall-mount
bracket, wall plugs and screws provided.
When selecting a location, ensure that there are no utility/service lines
(electrical wiring, water supply, gas supply, air etc.) located directly
behind the mounting location. Mount the bracket in accordance with
all applicable codes and requirements. The use of personal protective
equipment, such as safety glasses and gloves, is recommended.
1
Using the wall-mount bracket as a template, mark the location of
the screw holes.
Caution:
Do not mount the bracket more than 1 metre (3 feet) above the floor.
2
Using an 8mm (5/16-inch) drill bit, drill two pilot holes, and then
insert the wall plugs into the pilot holes.
Note:
If you are mounting the appliance directly onto a wall stud, it is not
necessary to install the wall plugs. Use the screws to secure the bracket onto the
wall stud.
3
Tighten the screws in the bracket
until the wall mount is held firmly
in place. Do not over-tighten.
Handheld Vacuum H1 Owner's Guide
EN
2
Advertisement
Table of Contents
