Singer Quantum Stylist 9960 Service Manual page 32

G. Top Cover
a b
To remove front cover the following covers needs to be
removed fi rst, The light cover, needle plate, base , thread
tension cover and the front cover.
1. Loosen the screws (a, b) located on the back side of
the machine.
d
c
2. Remove the screws (c, d) located on the top of the
machine
f
3. Push the front side of the unit cover (e).
The rear side of the unit cover (f) will come off.
4. Pull up the right side of the unit cover and pull out the
e
left side of cover from the space between thread guide
cover and handle.
a b
H. Rear Cover
Remove the all exterior parts until unit cover.
1. Lower the presser foot lifter.
2. Remover the 4 screws (a, b, c, d).
(Screw (b) is longer than others.)
d
c
3. Carefully disconnect the connector with holding the
lever (e).
e
This connector connects terminal box and power
circuit board.
4. Pull the left side of rear cover (f) to come off from
thread guide cover (g). Pull the rear cover backward and
remove it from the machine.
TM
32 Singer Quantum Stylist 9960