Ramsey Electronics WCT3 Manual page 16

31. Install R27, 10K ohm resistor
Almost there... let's do the 150K ohm resistor, marked 154.
32. Install R31, 150K ohm resistor
Locate the two(2) 330K ohm resistors marked 334.
33. Install R3, 330K ohm resistor
34. Install R6, 330K ohm resistor
Locate the last resistors, six(6) 3.9M ohm resistors, marked 395, (that's 3mil-
lion, 900 thousand ohms.. 3,900,000 ohms). Three(3) of these resistors will
be installed now and the 4th will be installed in a little while. Don't lose it!!!!
35. Install R2, 3.9M ohm resistor
36. Install R5, 3.9M ohm resistor
37. Install 3.9M ohm resistor R24
38. Install 3.9M ohm resistor R25
39 Install 3.9M ohm resistor R28
Why don't you take a little break at this point and check over your work. Make
sure there are no solder bridges between the installed components and other
pads. Also check that each location has the correct value.
REMEMBER!! DO NOT clean the circuit board!!!
Capacitor Installation:
Next we'll install the capacitors. With the exception of C3 all these capacitors
may be installed in either direction. Make sure to open only ONE package at
a time to avoid mixing up the values. This is especially true for the capacitors
since they have no markings of any kind.
Start buy locating the package of three(3) .001uF capacitors.
40. Install C2, .001uF capacitor
41. Install C11, .001uF capacitor
42. Install C13, .001uF capacitor
The ten(10) .0.01uF capacitors are next
43. Install C5, .01uF capacitor
44. Install C6, .01uF capacitor
45. Install C7, .01uF capacitor
46. Install C8, .01uF capacitor
WCT3  16