Related Manuals for Accu-Scope DS-360
Summary of Contents for Accu-Scope DS-360
- Page 1 MANUAL DS-360 DIASCOPIC STAND (CAT# 131-13-28) 73 Mall Drive, Commack, NY 11725 • 631-864-1000 (P) • 631-543-8900 (F) www.accu-scope.com • info@accu-scope.com...
-
Page 2: Table Of Contents
DS-360 Diascopic Stand CONTENTS INTRODUCTION ....................... 3 UNPACKING AND COMPONENTS ................3 ASSEMBLY......................4-6 OPERATION ......................7 TROUBLESHOOTING ....................8 MAINTENANCE ......................9 SERVICE ........................9 WARRANTY ......................9 ACCU-SCOPE ® 73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com... -
Page 3: Introduction
UNPACKING AND COMPONENTS Your DS-360 stand arrived packed in an environmentally friendly shipping carton. Do not discard the carton: the shipping carton should be retained for reshipment of your stand if needed. Avoid placing the stand (with or without microscope) in dusty surroundings or in high temperature or humid areas as mold and mildew can form. -
Page 4: Assembly
1. Carefully remove the contents of the box and place on a secure, flat surface. 2. Place the DS-360 stand on a flat surface Included: DS-360 stand with attached focus track and microscope mount, plastic arm rest, 180mm glass stage plate, LED light, power adapter/controller, AC line cord. - Page 5 Loosen the locking screw in the microscope mount and place your stereo microscope into the circular mount. Tighten the locking screw until snug, but do not overtighten. ACCU-SCOPE ® 73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com...
- Page 6 Plug the adapter/controller into the back of the LED light. Plug the AC line cord into the adapter/controller. Plug the other end into a suitable 110V AC receptacle. ACCU-SCOPE ® 73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com...
-
Page 7: Operation
5. Adjust the mirror for specimen viewing. The DS-360 is equipped with a two-sided mirror – one side is a polished mirror and the other side has a silver metallic (frosted) surface. While looking through the eyepieces and with the specimen in focus, slowly adjust the mirror angle using the mirror adjustment knob on the right side of the base. -
Page 8: Troubleshooting
Power cords are not secure Ensure the cords are inserted completely Lamp does not work LED has burned out Change the LED lamp AC adapter has failed Replace the AC adapter ACCU-SCOPE ® 73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com... -
Page 9: Maintenance
ACCU-SCOPE INC. This warranty expressly excludes any liability by ACCU-SCOPE INC. for consequential loss or damage on any grounds, such as (but not limited to) the non-availability to the End User of the product(s) under warranty or the need to repair work processes.