Page 1
EyeW485-H Wireless Communication Module Quick Use Manual 1 Application Scenarios EyeW485-H is applied to the new energy industry, especially the photovoltaic industry. For use with smart communication box developed and manufactured by SUNGROW in residential/industrial/utility/floating photovoltaic plants. It receives the inverter data transmitted by the EyeW485 via WiSun and in turn transmits it to the SunCloud.
Page 2
3 Description of the Indicator Status The EyeW485-Hneeds to be used with the EyeW485, both of which communicate wirelessly through WiSun to enable networking. The indicator status of EyeW485-H and EyeW485 is explained below. Description of the EyeW485-H indicator status Indicators...
(COM) communicating Note: Blinking is defined as blinking on for 1s and off for 1s and then repeats. 4 Troubleshooting Follow these steps to perform troubleshooting if the EyeW485-H indicators are in the following status. Fault Check method If necessary, open the cover and check whether the backplane supply voltage is DC5.0V with the multimeter;...
Page 4
Check method Check whether the EyeW485-His connected to external power; NET indicator off Check whether the EyeW485-H is connected. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 5
Caution! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. To maintain compliance with FCC’s RF Exposure guidelines, this equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.