Echo Shindaiwa HT235 Operator's Manual page 21

HT235
1. STOP Switch
Move STOP switch (A) to the
rear (towards the grip) to the "I"
or ON position.
2. Choke
Move choke (B) to COLD
START ( ) (closed) position.
3. Purge Bulb
Pump purge bulb (C) until fuel is
visible and flows freely in the
clear fuel tank return line. Pump
bulb an additional 4 or 5 times.
4. Recoil Starter
Lay the unit on a flat, clear area.
Grip the support handle securely
with one hand, and pull the recoil
starter handle (D) until engine
fires (or 2-3 pulls maximum).
5. Choke
After engine fires (or 2-3 pulls),
move choke (B) to the RUN (
(open) position. Restart engine if
necessary and allow unit to
warm up at idle for several
minutes.
Note: If engine does not start
with choke in "RUN"
position after 2-3 pulls,
repeat instructions 2 - 5.
X7712240502
© 06/22 ECHO Incorporated
A
C
)
OPERATION
B
D
B
21