Jumper Settings On The Cc3100Modboost; Jumper Settings On The Emuboost; The Cc3100Boost Connected To The Emuboost; Cc3100Modboost Jumper Settings - Texas Instruments CC3100MODBOOST User Manual

Connecting to the PC Using EMUBOOST
Figure 15. The CC3100BOOST Connected to the EMUBOOST
Align the pin-1 of the boards together using the triangle marking on the PCB.
An incorrect connection can destroy the boards permanently.
Ensure that none of the header pins are bent before connecting the two boards.
3.3

Jumper Settings on the CC3100MODBOOST

Table 8 specifies the jumpers to be installed on the CC3100MODBOOST before pairing with the
EMUBOOST board.
No. Jumper Settings
1 J8 (1-2)
3 J6 (short)
4 J5 (short)
3.4

Jumper Settings on the EMUBOOST

Table 9 specifies the jumpers to be installed while pairing with the FTDI board.
No. Jumper Settings
1 J4 (short)
2 J22 (short)
3 J3 (1-2)
16
CC3100MOD SimpleLink™ Wi-Fi® Network Processor Module BoosterPackSWRU396A – December 2014 – Revised September 2015
Hardware
CAUTION
Table 8. CC3100MODBOOST Jumper Settings
Power the BoosterPack from the EMU BOOST. Place the jumper near the edge of the
Table 9. EMUBOOST Jumper Settings
Copyright © 2014–2015, Texas Instruments Incorporated
Notes
PCB.
No current measurement
OOB demo jumper
Notes
Provide 3.3 V to the BoosterPack
Provide 5.0 V to the BoosterPack
Route the NWP logs to the dual port
www.ti.com
Submit Documentation Feedback