Table of Contents
Advertisement
hood installation
Step 8. Lift the hood into place,
aligning the duct if venting,
exercising care not to pinch
electrical wiring. Fasten in place
with
6 screws
Center 2 screws optional for added
support.
If venting check dampers
for free operation and tape seal
all duct joints.
Step 9. Connect the electrical power following the steps on the page 18.
Step 10. Replace the interior
liner removed in Step 2.
When disposing of the packing materials - please recycle.
as shown here.
cont.
REPLACE THESE 6 SCREWS
Step 11. Replace the stainless steel
grease filters removed in Step 1 and
you are all done.
- 21 -
Advertisement
Table of Contents
