Table of Contents
Advertisement
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
Switch off the appliance. Disconnect
1.
the mains plug.
Drain the detergent solution
2.
Pull the emergency release
3.
downwards with a tool and release.
The washing machine door can then
be opened.
Information on the display panel
Display
YES
NO
¼ flashes
E:17
E:18
E:23
E
9 flashes
Other displays
.
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
■
door immediately, if open. Select Start/Reload to continue the programme.
Laundry may be caught. Please open and close the washing machine door
■
again and select Start/Reload .
If necessary, push the washing machine door closed or remove the laundry and
■
push it closed again.
If required, switch appliance off and on again; set the programme and make
■
individual settings; start the programme.
Turn the water tap on fully,
■
supply hose kinked or trapped,
■
water pressure too low. Clean the filter.
■
Detergent solution pump blocked. Clean detergent solution pump.
■
The drain hose/waste pipe is blocked. Clean the drain hose on the siphon.
■
Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales ser-
vice.
Childproof lock activated; deactivate it.
Too much foam detected, a rinse cycle has been switched on
Switch off appliance, wait five seconds and switch on again. If the display is indi-
cated again, call the after-sales service
Faults and what to do about them.
en
25
Advertisement
Table of Contents
