Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bosch WAK282M8SN
Summary of Contents for Bosch WAK282M8SN
- Page 1 Washing machine WAK282M8SN en Instruction Manual and Installation Instructions...
- Page 2 Your new washing machine Display rules : Warning! You have chosen a Bosch washing machine. This combination of symbol and signal word indicates a possibly dangerous Please take a few minutes to read and situation. Not heeding the warning can become familiar with the advantages of cause death or injuries.
-
Page 3: Table Of Contents
Contents e n I n s t r u c t i o n M a n u a l a n d I n s t a l l a t i o n I n s t r u c t i o n s Intended use. -
Page 4: Intended Use
Intended use After-sales service ..28 Intended use I n t e n d e d u s e Consumption rates ..29 For private domestic use only. -
Page 5: Safety Instructions
Safety instructions Reaching into the drum Safety instructions ■ when it is turning can cause injuries to hands. S a f e t o n s u c t i i n s t r Electrical safety Do not reach into the drum when it is turning. - Page 6 Safety instructions Cut through the mains cable Warning ■ and remove it, along with Eye/skin irritation! plug. Detergents and care products Destroy the lock on the may cause irritation if they ■ washing machine door. come into contact with the eyes or skin.
-
Page 7: Environmental Protection
Environmental protection Save energy and detergent when ■ Environmental washing lightly and normally soiled laundry. ~ Page 12 protection Energy-saving mode: The display o n m e n t a l E n v i r c t i p r o t e ■... -
Page 8: Main Points In Brief
Main points in brief Main points in brief M a i n p o i n t b r i e Connect the mains Turn on the water Sort the laundry. Open the door. plug. tap. -------- Select a programme Observe the Load the laundry . -
Page 9: Getting To Know The Appliance
Getting to know the appliance Getting to know the appliance i n g G e t t k n o w t h e a n c e a p p l i Washing machine ( Detergent drawer ~ Page 18 8 Washing machine door with window handle 0 Controls/display elements 9S Open the washing machine door... -
Page 10: Control Panel
Getting to know the appliance Control panel ( °C (Temperature), 0 (pin speed), 3 (Ready @ Programme selector for selecting a in) -time for changing the programme default programme and for switching the machine on settings and off 0 G (Speed Perfect) , F ü (Eco H Display panel for settings and information Perfect), Z (Water Plus) additional programme settings... -
Page 11: Laundry
Laundry You can find examples of levels of Laundry soiling on ~ Page 12 – Light: Do not prewash, select the L a u n d r y Speed Perfect setting if Prepare the laundry necessary – Normal Caution! – Heavy: Load less laundry, select Damage to the appliance/fabrics a programme with prewash Foreign objects (e.g. -
Page 12: Detergent
Detergent Detergent Saving Soiling/note Reduced temper- Light g e n t D e t e r ature and deter- No visible dirt or stains. Cloth- Correct selection of detergent gent quantity as ing has taken on some body per the recom- odour, e.g.: The care label is crucial for selecting mended dosage... -
Page 13: Overview Of Programmes
Overview of programmes Overview of programmes O v e r v i p r o g r a m m e s Programmes on the programme selector Programme/type of laundry/information Settings Max. load; Name of programme Short explanation of the programme or the fabric for which it is suita- * Reduced load for (Speed Perfect) ble. - Page 14 Overview of programmes Programme/type of laundry/information Settings W Wool max. 2 kg Hand or machine-washable fabrics made of wool or that contain Cold - 40 °C wool; – – – ... 800 rpm particularly gentle wash programme to prevent shrinkage of laundry, with longer programme breaks (fabrics rest in the detergent solu- tion) Notes...
-
Page 15: Starching
Overview of programmes Programme/type of laundry/information Settings Allergy+ max. 7 kg/5* kg Hard-wearing fabrics Cold - 60 °C Note: Longer washing and rinsing at a higher water level for particu- – – – ... 1400** rpm larly sensitive skin F, G, Z max. -
Page 16: Programme Default Settings
Programme default settings The maximum speed that can be set Programme default depends on the model and programme that have been selected. settings Overview of programmes ~ Page 13 P r o g r a m m e d e f a u l i n g s s e t t The temperature, spin speed and... -
Page 17: Additional Programme Settings17
Additional programme settings The symbols YES and ¼ light up on Operating the the display panel. The washing machine door can be opened and appliance laundry can be added. Close the washing machine door. i n g O p e r a t t h e a n c e a p p l i... -
Page 18: Change The Programme Default Settings
Operating the appliance Change the programme Notes Mix items of laundry of varying sizes. default settings ■ Laundry items of different sizes distribute themselves better during You can use the default settings or the spin cycle. Individual items of change them. laundry may lead to imbalances. -
Page 19: Start The Programme
Operating the appliance Measure the detergent and care Close the detergent drawer. products according to: Measuring aid* for liquid detergent Water hardness; ask your water ■ *depending on the model supply company The manufacturer's instructions on ■ Position the measuring aid for the packaging measuring the correct amount of liquid The amount of laundry... -
Page 20: Childproof Lock
Operating the appliance Childproof lock A flashing NO symbol, wait until YES ■ and ¼ light up. You can lock the washing machine to Do not open the door until both the prevent the functions you have set from YES and the ¼ symbols are lit. being changed inadvertently. -
Page 21: Programme End
Sensors Programme end If the display panel goes off at the ■ end of a programme, energy-saving End appears on the display panel and mode is active. To activate the panel, the Start/Pause button indicator lamp is press any button. off. -
Page 22: Setting The Signal
Setting the signal Setting the signal i n g S e t t t h e s i g n a l 1. Activate the setting mode for the signal volume Set to Ú. Press and hold the 0 button and turn one Press and hold the button for approx. -
Page 23: Cleaning And Maintenance
Cleaning and maintenance descaling agent. Suitable descalers can Cleaning and be obtained via our website or from our after-sales service. maintenance C l e a n i a n d e n a n c e m a i n t Detergent drawer and housing Warning Danger of death! -
Page 24: The Drain Hose At The Siphon Is Blocked
Cleaning and maintenance Switch off the appliance. Disconnect the mains plug. Open and remove the service flap. To prevent unused detergent Note: from flowing straight into the drain during the next wash: Pour 1 litre of Take the drain hose out of the water into compartment II and start the retainer. -
Page 25: Faults And What To Do About Them
Faults and what to do about them. Remove the hose from the water tap. if you come into contact with detergent Clean the filter with a small brush. solution and laundry. If possible, leave it to cool down. Warning Risk of injury! You may injure your hands if you reach into the drum while it is turning. -
Page 26: Information On The Display Panel
Faults and what to do about them. Information on the display panel Display Cause/remedial action The washing machine door is unlocked. It is possible to add laundry. Temperature too high. Wait until the temperature drops. ■ Water level too high. Not possible to add laundry. Close the washing machine ■... - Page 27 Faults and what to do about them. Faults Cause/remedial action Detergent solution is not – – – 0 (Rinse hold = without final spin) selected? ■ emptied. Clean detergent solution pump. ■ Clean the waste pipe and/or drainage hose. ■ Water not visible in the Not a fault –...
-
Page 28: After-Sales Service
After-sales service Faults Cause/remedial action YES appears on the dis- The washing machine door is unlocked. It is possible to add laundry. play in reload mode. If you cannot correct a fault yourself (after switching off/on) or a repair is required: Turn the programme selector to Stop. -
Page 29: Consumption Rates
Consumption rates Consumption rates C o n s u m p t i r a t e s Energy and water consumption, programme duration and residual moisture for the main washing programmes (approximate information) Programme Load Energy consumption* Water* Programme duration* Cottons 20 °C 8 kg 0,40 kWh... -
Page 30: Technical Data
Technical data Standard-Programs for Cotton under EU-Regulation 1015/ Load Programme du- 2010 ration Programme Cottons ú + button ü EcoPerfect F 8 kg 3 ^ h Programme Cottons ú + button ü EcoPerfect F 4 kg 3 ^ h Programme Cottons û + button ü EcoPerfect F 4 kg 3 ] h Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU with... -
Page 31: Positioning And Connecting
Positioning and connecting H Elbow for securing the water drain hose* Positioning and P Water supply hose on standard/Aqua- connecting Secure models i o n i n g P o s i t a n d c o n n e c t i *depending on the model Included with the appliance In addition, a hose clamp ( 24 - 40 mm... -
Page 32: Installation Surface
Positioning and connecting under high water pressure. To prevent Do not remove the appliance covering leaks and water damage, you must plate. follow the instructions in this section. Notes Notes Recess width of 60 cm required. ■ In addition to the safety information Only install the washing machine ■... -
Page 33: Hose And Cable Lengths
Positioning and connecting Unscrew and remove all four transport brace screws. Remove the sleeves. To do this, remove the mains cable from the holders. Fit the covers. Lock the covers firmly The following are available from Tip: in place by applying pressure to the specialist dealers/the after-sales snap-in hooks. -
Page 34: Water Outlet
Positioning and connecting Only tighten the screw connections Open the water tap carefully, Note: ■ by hand. If the screw connections checking the leak tightness of the are tightened too much with a tool connection points. The screw (pliers), the thread may be connection is under mains water damaged. -
Page 35: Levelling
Positioning and connecting In doing so, hold the foot tight and do not adjust its height. The lock nuts on all four appliance feet must be screwed tightly against the housing. Drainage into a siphon ■ The connection point must be secured using a hose clamp with a diameter of 24-40 mm (available from specialist dealers). -
Page 36: Before Washing For The First Time
Positioning and connecting The mains cable is only replaced by To prevent foaming, only use Note: ■ a qualified electrician (if this is half of the amount of detergent necessary). Replacement mains recommended by the detergent cables are available from the after- manufacturer. - Page 37 Positioning and connecting Before initial use: Notes The transport locks must be ■ removed. To prevent unused detergent from ■ flowing straight into the drain during the next wash: Pour approximately 1 litre of water into compartment II and select and start the [ Empty programme.
- Page 40 A call set-up fee of up 6 pence may apply.) 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.) You can find the contact information for all countries in the attached after-sales service directory. Robert Bosch, Hausgeräte GmbH Carl-Wery-Straße 34 81739 München DEUTSCHLAND...