Table of Contents
Advertisement
26
www.electrolux.com
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When
set the necessary procedure:
Option
P1
P2
Press
or turn the knob for the
temperature to start the procedure.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. When the oven is at its set
temperature, the door locks. The
display shows the symbol
bars of the heat indicator until the
door unlocks.
To stop Pyrolysis before it is
completed, turn the knob for the oven
functions to the off position.
6. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
7. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
10.5 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
flashes, press
or
Description
If the oven is
not very
dirty. Time of
the proce‐
dure: 1 h 30
min.
If you cannot
easily re‐
move the
dirt. Time of
the proce‐
dure: 2 h 30
min.
and the
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press
to
the same time while PYR
flashes in the display.
10.6 Cleaning the oven door
The oven door has four glass panels.
You can remove the oven door and the
internal glass panels to clean them.
The oven door can close if
you try to remove the glass
panels before you remove
the oven door.
CAUTION!
Do not use the appliance
without the glass panels.
1. Open the door fully and hold the two
door hinges.
2. Lift and turn the levers on the two
hinges.
and
at
Advertisement
Table of Contents
