3. When there is no microwave oscillation
1) When touching START pad, oven lamp does not turn on.
Fan motor do not rotate, but cook indicator in display comes on.
* Cause : RELAY 2 does not operate. ¡ æ refer to Circuit Diagram ( Point 3)
- Check method
STATE
RELAY 2 ON
RELAY 2 OFF
2) When touching START pad, oven lamp turns on.
Fan motor and turntable rotate and cook indicator in display comes on.
* Cause : RELAY 1 does not operate. ¡ æ refer to Circuit Diagram ( Point 2 )
- Check method
STATE
RELAY 1 ON
RELAY 1 OFF
4. When there is no grill oscillation.
* Cause :RELAY3 does not operate ¡ æ refer to circuit Diagram (point 6)
- Check method
STATE
RELAY3 ON
RELAY3 OFF
5. When the door is opened during operation, the count down timer does not stop.
¡ æ refer to Circuit Diagram( Point 1 )
- Check method
STATE
1) DOOR OPEN
2) DOOR CLOSED
CHECK NO
Check the stage(ON,OFF) of the door open monitor switch by resistance
1
measurement.
6. When the digital clock does not operate properly.
¡ æ refer to Circuit Diagram( Point 5 )
POINT
A
¡ Ø If clock does not keep exact time, you must check resistor R15,16, zener diodeZD1.
POINT
POINT
POINT
POINT
METHOD
T: 16.67 ms(60Hz)
A
- 5VDC
GND
A
-5VDC
GND
A
-5VDC
GND
A
OPEN
CLOSE
WAVE FORM
29
PRINTED CIRCUIT BOARD
B
GND
- 12VDC
B
GND
-12VDC
B
GND
-12VDC
B
-5VDC
GND
REMEDY
Replace door open monitor switch.