Table of Contents
Advertisement
Quick Links
Avanti Designer Table U-7100
Contents of Carton:
[2] A-Base Ends [A]
[2] A-Base Cross Supports [C]
[2] Chanelled Side Supports [D]
[1] Upper Cross ESupport [E]
[1] Chanelled Cross Member with Threaded Rod [F]
[2] Drawing Top Braces [G]
Tools needed for assembly:
Phillips Screwdriver, Flat Screwdriver
or Power Drill and Hammer (to tap holes into
drawing board during attachment)
IMPORTANT
If you have difficulty assembling your U-7100 Avanti Base
or need customer service assistance.
Please call: Martin Universal Design, Inc.
Customer Service Hot Line at
1-313-895-0700. If you need additional parts, it is not
necessary to contact your dealer, our Customer Service
Rep. will forward them to you immediately.
Assembly Instructions
[2] Left & Right Legs
for A-Base [B]
4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709
Email: Custservmud@aol.com • visit us at www.MartinUniversalDesign.com
Contents of Parts Bag:
[1] ThreadedLever [AA]
[1] Female Knob
[2] Male Knob [DD]
[CC]
[2] Female Knobs
[2] Large Pin with
with bolt & washer
included [FF]
[12] Long Wood
[2] 1-3/4" Bolts
Screws [GG]
[2] Metal Tilt Adjustment Rods [JJ]
[2] Metal Pin End Caps for Tilt Rods [KK]
[1] Large Washer for Lever
[BB]
[1] Washer for
Female Knob
[EE]
[2] "C" Washers for
hole [EE]
Large Pins
[FF]
[4] Small Wood
[HH]
Screws [II]
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Martin Avanti U-7100
Summary of Contents for Martin Avanti U-7100
- Page 1 IMPORTANT If you have difficulty assembling your U-7100 Avanti Base or need customer service assistance. Please call: Martin Universal Design, Inc. Customer Service Hot Line at 1-313-895-0700. If you need additional parts, it is not necessary to contact your dealer, our Customer Service [2] Metal Pin End Caps for Tilt Rods [KK] Rep.
- Page 2 Assembly Instructions: STEP 1] Assembling A-Base(s) STEP 3] Attaching Channelled Side Take the A-Base end [A] as shown below and the Left Leg [B] Take A-Base end that has the two supports attached and place for the A-Base. on flat surface. Position Channelled Side Support [D] into Long Wood middle section of A-Base.
- Page 3 Assembly Instructions continued: STEP 5] Securing Lower Support & Rod STEP 7] Inserting Pin into Side Support Repeat with other A-Base assembly on other side. Take the [2] Large Pins with Hole [EE] and insert each one First by sliding Channelled Side Support [D] down into A-Base into the hole which is below cross support bolt.
- Page 4 Assembly Instructions continued: Before securing base of table to 30” x 42” Drawing Board top, you STEP 10] Attaching Top Braces must center the base to the top. When attaching the [2] Drawing Top Braces [G], position the drawing board brace in the position shown here: Rear Edge of Top Attach to the inside of the Side Support [D] using the [2] remaining knobs, washers and bolts [F].
Need help?
Do you have a question about the Avanti U-7100 and is the answer not in the manual?
Questions and answers