Cautions And Warnings - Sony KDL-32R434A Repair Manual

CAUTIONS AND WARNINGS

CAUTION!!
These servicing instructions are for use by qualified service personnel only.
To reduce the risk of electric shock, do not perform any servicing other than
that contained in the operating instructions unless you are qualified to do so.
WARNING!!
An isolation transformer should be used during any service to avoid possible
shock hazard, in case of live chassis.
SAFETY-RELATED COMPONENT WARNING!!
!
There are critical components used in LCD color TVs that are important for
safety. These components are identified with shading and
schematic diagrams and the parts list. It is essential that these critical parts
be replaced only with the part number specified in the parts list to prevent
electric shock, fire or other hazard.
NOTE: Do not modify the original design without obtaining written permission
from the manufacturer or you will void the original parts and labor warranty.
ATTENTION!!
For safety reasons, component level repair of the Power Supply Boards
and/or the Inverter Boards is prohibited.
KDL-32R434A ii
After correcting the original service problem, perform the following safety
checks before releasing the set to the customer:
Check the area of your repair for unsoldered or poorly soldered
1.
connections. Check the entire board surface for solder splashes
and bridges.
Check the interboard wiring to ensure that no wires are "pinched" or
2.
touching high-wattage resistors.
Check that all control knobs, shields, covers, ground straps and
3.
mounting hardware have been replaced. Be absolutely certain that
you have replaced all the insulators.
Look for unauthorized replacement parts, particularly transistors,
4.
that were installed during a previous repair. Point them out to the
mark on the
! customer and recommend their replacement.
Look for parts which, though functioning, show obvious signs of
5.
deterioration. Point them out to the customer and recommend their
Check the line cords for cracks and abrasion. Recommend the
6.
replacement of any such line cord to the customer.
Check the antenna terminals, metal trim, "metallized" knobs, screws
7.
and all other exposed metal parts for AC leakage. Check leakage
as described in "Leakage Test".
SAFETY CHECK-OUT
replacement.