SAMSUNG DCS
T E C H N I C AL MANUAL
PART 8. INSTALLING KEYSET
D A U G H T E R B O A R D S
8.1 KDB–S L I
1) Unplug line code of the phone before performing this procedure. (Figure 8–1)
2) Remove with a driver molding subtances of expansion module of base housing. (Figure 8–3)
3) Remove extra molding subtances by the same method as no.2. (Figure 8–2)
4) Mount module KDB – SLI. (Figure 8–4)
5) Thighten two (2) screws of KDB –SLI. (Figure 8–5)
6) Connect modular jack of phone line with DLI line of basic system. (Figure 8–6)
7) Connect extra modular jack with a general phone. (Figure 8–7 & 8–9)
8.2 KDB– D L I
1) Unplug line code of the phone before performing this procedure. (Figure 8–1)
2) Remove with a driver molding subtances of expansion module of base housing. (Figure 8–3)
3) Remove extra molding subtances by the same method as no.2. (Figure 8–2)
4) Mount module KDB –DLI. (Figure 8–4)
5) Thighten two (2) screws of KDB – DLI. (Figure 8–5)
6) Connect modular jack of phone line with DLI line of basic system. (Figure 8–6)
7) Connect extra modular jack with a key phone. (Figure 8–7 & 8–8)
8.3 CONNECTING TO THE KDB– D & KDB–S
See Figure 8–7, 8–8 and 8–9.
8-1
INSTALLATION
A P R I L 1 9 9 6