Table of Contents
Advertisement
Operation of vacuuming dusts
1. Make sure the power cord is disconnected from the socket.（Fig1）
2. Loose Clips.（Fig 2）
3. Raise the Head assembly from the dust tank. (Fig 3)
4. Install the cloth filter in the battel in turn.(Fig.4)
5）
5. Place the nose assembly on a dust bucket, and lock it with both sides of the buckle(Fig
6. Align the hose assembly port with the suction port, and then rotate it to the right and insert
it. (Fig 6)
7. Connect telescopic tube with the hose (Fig 7).
8. The telescopic tube can be adjust to different length (Fig 8)
9. Connect floor nozzle with telescopic tube (Fig 9)
10. Start the switch button. (Fig 10)
11. Start the vacuum. (Fig 11)
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE
GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE
PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE
NOT LIMITED TO;COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF
HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
Advertisement
Table of Contents
