Table of Contents
Advertisement
Caution： Make sure that the power cord plug and socket are de-energized
when assembling the vacuum cleaner
Open the vacuum cleaner you purchased
1. Make sure the power cord is disconnected from the socket（Fig1）
2. Loose Clips（Fig2）
3. Raise the nose assembly from the dust pan. (Fig 3)
4. Remove the internal accessory. (Fig 4)
5. Install the wheels. Align the corresponding holes, pressure down, and install the four
caster on the barrel. (Fig 5)
6. Install the cloth filter in the battel in turn.(Fig.6)
7. Place the top cover assembly on the dust bucket and lock it with both sides of the buckle.
(Fig.7)
8. Align the hose assembly port with the suction port and insert it to the right and tighten it.
(Fig.8)
9. Connect telescopic tube with the hose (Fig 9)
10. The telescopic tube can be adjust to different length (Fig 10)
11. Connect floor nozzle with telescopic tube (Fig 11)
Switch
Press "
Press "
Socket
1. Open the power tool socket cover. (Fig.1)
2. Insert the power cord switch and apply pressure to the bottom. (Fig.2)
3.
Start the switch.
WARNING: Before inserting the tool socket, check that the tool you are using is
secure and safe.
Start vacuum
"
Turn off vacuum
"
（Fig.3）
Max. load of socket-out: 1500W.
Advertisement
Table of Contents
