Storage And Maintenance; Technical Data - HOGERT HT2C107 User Manual

8. Hold the glue gun by insulated parts, such as the handle intended for it and avoid body contact with electrically conductive and
earthed parts when operating. Do not use the glue gun in combination with flammable materials
9. Pole tekstoweDo not tilt the glue gun backwards and do not lay it on its side when operating; when it is not used, the glue gun
should always be placed in an vertical position on the stand. For longer breaks in operation (longer than approx. 30 minutes),
disconnect the device from the power supply.
10. Do not touch heated elements in the device (glue gun nozzle and glue); in the event of hot glue contact with the skin, immediately
pour cold water on burn.
11. Glue gun must be kept out of reach of children.
12. Do not expose the device to direct sunlight, rain, etc .; use only in dry rooms.
13. All repairs of the glue gun should be carried out by the service centres using proper spare parts.
14. Pole tekstoweIt is forbidden to make any structural changes. Unauthorized structural changes will result in voiding the warranty
and they may cause the glue gun malfunction or accident.
15. Do not exceed rated operation parameters of the glue gun.
16. The glue gun should always be disconnected from the power socket and stored in a safe, clean, dry place, out of the reach of chil-
dren and animals when it is not operated.
17. Used electrical equipment may not be stored together with municipal waste. Used electrical devices should be stored in places
designated for this purpose.
USER MANUAL
Insert a stick of glue in correct size and press the trigger gently several times to position the stick correctly. Place the glue gun on the
wire stand. Put some paperboard or a piece of wood under the nozzle outlet. Plug the glue gun into the power socket and wait till glue
will warm up [approx. 6 minutes Press the trigger and apply glue to one of the joined pieces. Squeeze joined parts and adjust their
position if necessary before the joint hardens. After use, put the device back on the stand and let it cool down. Do not take out the glue
residue. Wait until the glue gun cools down and then put it in a dry, clean and safe place, away from children and animals.

STORAGE AND MAINTENANCE

1. Clean the glue gun housing with a soft, dry cloth. It is easiest to remove glue droplets when they are cold. Before cleaning, disconnect
the glue gun from the power socket and wait until it cools down.
2. The glue gun should be stored in a dry place, away from children and animals.
3. When you finish using the glue gun, wait until body and nozzle cool down, then put the glue gun in some place.

TECHNICAL DATA

Glue gun HT2C107
Power supply voltage
Frequency
Rated power
Working temperature
Diameter of glue stick
Flow of glue
MAINTENANCE
If necessary, use a soft cloth to wipe the surface of the gauge. Do not use organic solvents or abrasive materials that may cause cor-
rosion or dissolution of housing.
4
230 V-
50 Hz
100 W
240 -260°C
11,2 mm
13~30 g/min
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków www.hoegert.com