Installation Of Heater - Dimplex AC3CE Instruction Manual

Installation of Heater

The Installation of this product must be carried out by a prescribed competent per-
son in accordance with the Building Regulations and the current IEE Wiring Reg-
ulations for electrical equipment. Only heat resistant ordinary polyvinyl chloride
sheathed fl exible cord should be used. IE60227 IEC57, rated T90
This heater can either be installed into a suspended or plasterboard ceiling. First it is
necessary to ensure that there is suffi cient space above the ceiling for the Installa-
tion of this product (see Fig. 1 and Fig. 5).
This product is designed to be suspended by threaded rod or wires/chains. Always
ensure this unit is adequately supported when installed.
Installation in a Ceiling
A hole as indicated in Fig. 1 and Fig. 4 must be cut into the ceiling. Allow an addi-
tional amount for clearance. It may be necessary to fi x an internal supporting frame
around the newly cut aperture in a plasterboard ceiling or suspended ceiling
Fig. 4
To mount the unit into the ceiling void, use lengths of threaded bar or hooks (not
supplied) screwed into the M8 threaded inserts located in the top side of the heater
(see Fig. 1 for dimensions). Adjust the height of the heater so the inner edge of the
grill surround is fl ush with the ceiling.
9