Advertisement
1. Mounting the Enclosure
This section will describe the process of mounting the Controller Integration enclosure in your car
wash.
The First task is to find a suitable location. The following conditions must be met:
1. Easy access to 120VAC power to provide power for the enclosure.
2. Less than 100ft ethernet cable length between the enclosure and the Washify network hub. Avoid
running the ethernet cable near equipment that causes large levels or electrical noise (Electric
Motors, Electric Pumps, Power Inverters).
3. Less than 30ft of integration wiring between the enclosure and the ICS PBS. Avoid running the
ethernet cable near equipment that causes large levels or electrical noise (Electric Motors, Electric
Pumps, Power Inverters).
After choosing a suitable location. You will need to mount the enclosure. Inside the enclosure are 4
metal stands. These stands screw into the back of the box and provide an elevation off of the wall.
They also allow you to mount the enclosure without needing to drill holes into the back of the
enclosure. Mounting screws and method of mounting is left to the discretion of the installer.
Advertisement
