Disassembly & Assembly - UWANT X100 Instruction Manual

Disassembly & Assembly
Installing Handle
1. Insert the end of the handle into the port
of the main unit in the vertical direction
until there is a click sound. Make sure that
the handle is tight, that is, the installation
is successful.
Instructions for disassembly and assembly of clear water tank
1. To remove the clean water tank, hold the
body with one hand, press the clean water
tank button with the other hand, pull it out
as shown in the figure and take out the
clean water tank.
How to Use／Disassembly & Assembly
2. To disassemble, insert a hard object into
the hole in the position as shown in the
figure, press the elastic needle, and pull
the handle upward at the same time.
2. To install the clean water tank, put the
bottom of the clean water tank into the
opening of the body, and then gently push
the clean water tank until there is a click,
which indicates that the installation is
successful.
04