Table of Contents
Advertisement
Introduction for buttons on remote controller
ON/OFF
1
:
Press this button to turn on the unit. Press this button again to turn off the unit.
:
2
Press this button to decrease set temperature. Holding it down above 2 seconds rapidly decreases
set temperature. In AUTO mode, set temperature is not adjustable.
+
:
Press this button to increase set temperature. Holding it down above 2 seconds rapidly increases set
temperature. In AUTO mode, set temperature is not adjustable.
MODE :
3
Each time you press this button , a mode is selected in a sequence that goes from AUTO,
COOL, DRY, FAN, and HEAT
COOL
AUTO
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be
displayed on the LCD, and the unit will automatically select the suitable operation mode in
accordance with the room temperature to make indoor room comfortable.(As for cooling only unit,
it won't have any action when it receives the signal of heating operation.)
FAN:
4
This button is used for setting Fan Speed in the sequence that goes from AUTO,
,
Auto
Low speed
SWING:
5
Press this button to set up &down swing angle, which circularly changes as below:
This remote controller is universal. If any command
the unit will carry out the command as
indicates the guide louver swings as:
I FEEL:
6
Press this button to turn on I FEEL function. The unit automatically adjust temperature according
to the sensed temperature. Press this button again to cancel I FEEL function.
*
, as the following:
*
FAN
HEAT
DRY
,
then back to Auto.
to
Low-Medium speed
Medium-High speed
OFF
*Note:Only for models with heating function.
High speed
,
or
4
,
Medium speed
is sent out,
,
Advertisement
Table of Contents
