Table of Contents
Advertisement
Introduction for buttons on remote controller
X-FAN:
15
Pressing X-FAN button in COOL or DRY mode, the icon
fan will continue operation for 2 minutes in order to dry the indoor unit even though you
have turned off the unit.
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO, FAN or
HEAT mode.
16
Combination of "+"and "-" buttons: About lock
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote
controller is locked,
three times.
Combination of "MODE " and "-" buttons : About switch between Fahrenheit and centigrade
17
At unit OFF, press
Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
18
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
Combination of " TEMP " and "CLOCK" buttons: About 8℃
19
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start
Nixie tube on the remote controller displays "
(46
if
Fahrenheit is adopted). Repeat the operation to quit the function.
℉
20
About Back-lighting Function
The unit lights for 4s when energizing for the first time, and 3s for later press.
Replacement of batteries in remote controller
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
★
Notes :
●
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
●
If the remote controller will not be used for a long time, please
remove batteries to prevent batteries from leaking.
●
The operation should be performed in its receiving range.
●
It should be kept 1m away from the TV set or stereo sound sets.
●
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds.If it still can't operate properly,
replace the batteries.
is displayed. In this case, pressing any button,
"
"
" -"
MODE
and
buttons simultaneously to switch between
is displayed and the indoor
Heating Function
" and a selected temperature of " 8℃ "
7
blinks
and
℃
℉
8℃
Heating Function
.
Sketch map for
replacing batteries
.
Advertisement
Table of Contents
