Table of Contents
Advertisement
Installation of indoor unit
2. Make the power connection wire go
through the cable-cross hole at the back
of indoor unit and then pull it out from
the front side.
3. Remove the wire clip; connect the power
connection wire to the wiring terminal
according to the color; tighten the screw
with wire clip.
Note: the wiring board is for reference only,
please refer to the actual one.
4.Put wiring cover back and then tighten the screw.
5.Close the panel.
Note:
● All wires of indoor unit and outdoor unit should be connected by a professional.
for a new one. Avoid extending the wire by yourself.
installation.
● For the air conditioner without plug, an air switch must be installed in the line.
The air switch should be all-pole parting and the contact parting distance should
be more than 3mm.
wiring board grounding
wire
N
( 1 )
2
3
wire clip
cable-cross
hole
power connection
wire
07、09、12、18K Heat Pump Type:
outdoor unit connection
21
yellow-
brown
green
Advertisement
Table of Contents
