Operation - Bibby Sterilin stuart SSM1 Instructions For Use Manual

5. Operation

5.1 Setting the speed
Start/stop button
Switch the unit ON by pressing the control knob
in (see fig 3). The unit will carry out a self test
routine and then the red display will show the
last stored set speed (red dot in the display
shows RPM is selected). This can be adjusted by
turning the control knob. Once the correct speed
is displayed press the start / stop button to begin
motion.
The speed can be adjusted without halting the
unit.
The unit can be halted at any time by pressing
the start / stop button.
5.2 Setting the timer.
In order to use the timer, halt rotation and press
the mode button. The red dot on the display
moves over to time. The display will show the
last stored time in minutes.
Select the desired count down time using the
control knob. When the display shows the
correct time in minutes, press the start / stop
button to begin operating.
During operation, motion can be paused at any
time by pressing the start / stop button. If the
button is pressed again, motion will start again
and the timer will continue to count down.
The timer can be adjusted without halting the
unit.
When the timer reaches zero, the unit will be
4
Mode button
Red digital display
Control knob
automatically halted and an alert will sound.
Press the start / stop button to revert back to the
last time and speed values set or select new
values following instructions given above.
N.B To disable the timer and revert to
continuous rotation, select - - - in the
display during timer mode.
To switch the unit OFF completely, press the
control knob in. The display will show OFF.
5.3 Saving speed/time values.
In order to save a commonly used speed/time
value, switch the unit ON by pressing the control
knob in (see fig 3).
Select both a speed value and a time value
(either 1 to 999 minutes, or continuous - - -)
using the instruction given above.
Switch the unit OFF by pressing in the control
knob. Wait 5 seconds and switch the unit back
ON by pressing the control knob in.
The input values are now saved in memory. They
can be altered at any time by following the same
procedure.
N.B. When the unit is switched OFF using
the control knob, whatever values of
speed/time were set prior to turning the
unit off will be saved, and will be the values
restored when the unit is switched back on.
Figure 3