Table of Contents
Advertisement
Quick Links
INSTRUCTIONS FOR
INSTALLATION AND OPERATION
The information in this instruction man-
ual covers the installation, operation, and
maintenance of the V5.7-34.2AC Motor-
ized Zoom Lens.
This unit must be installed y qualified
personnel using approved materials in
conformance with national, state, and lo-
cal electrical codes. Read these instruc-
tions completely before attempting to
install or operate this unit.
Do not exceed the maximum recommended
distances between a lens and its control unit.
NOTE: The front element of a zoom
lens moves in and out as the lens focus is
changed. The closest focusing position
corresponds to the greatest extension
the lens. When installing a lens in a
Product specifications subject to change without notice.
TEL: 516-952-CCTV
1. INTRODUCTION
2. INSTALLATION
of
INDUSTRIES INC.
89 ARKAY DRIVE, HAUPPAUGE, NY 11788
(2288) TOLL FREE: l-800-645-91 16 FAX: 516-951 -CCTV (2288)
The V5.7-34.2AC lens features motor-
ized zoom and focus plus electronic cir-
cuitry for automatic iris control, as well
s a neutral-density spot filter. The lens
provides optimum viewing contrast re-
gardless of light conditions or brightness
variations within the scene.
This lens is powered with 8.516 VDC
power from the camera.
housing, make sure that the lens is jidy
extended. Allow l/4-inch (0.6 cm) of
clear space between the extended lens
and the window.
INFOFAX: i-800-287-1 207
Advertisement
Table of Contents
Related Manuals for Vicon V5.7-34.2AC
Summary of Contents for Vicon V5.7-34.2AC
- Page 1 INSTRUCTIONS FOR INSTALLATION AND OPERATION 1. INTRODUCTION The information in this instruction man- The V5.7-34.2AC lens features motor- ized zoom and focus plus electronic cir- ual covers the installation, operation, and maintenance of the V5.7-34.2AC Motor- cuitry for automatic iris control, as well ized Zoom Lens.
- Page 2 CAUTION: Control units having the CAUTION: Do not mount an autoiris distance switWch on a autopanning unit. Such use MUST NOT be set for longer than will cause excessive wear, as the recommended distances or the lens iris mechanism constantly compen- may be seriously damaged.
- Page 3 3. Zoom in to the maximum telephoto 2. Adjust the back focus by positioning the camera 25-50 feet (7.6-15 m) from position and focus the lens. Zoom out, a flat vertical surface suitable for fo- watching the focus on the monitor. If the image goes out of focus.
- Page 4 2. Attach a sheet of paper to the eturning a unit to the factory: unit with the following informa- tion: 1. Call or write Vicon for a Return Authorization (R.A.) at one of a. Name and address of the company returning the unit the locations listed below.
- Page 5 AC LENS VIEW OF WIRING SIDE USED ZOOM LENS WITH PRESET FOCUS LENS COMMON ERROR RETURN ERROR SUP (+12V) ZOOM WIPER FOCUS WIPER VIEW OF WIRING SIDE S H I E L D Figure 1 Connector Diagram, AC Lenses Figure 2 Lens Adjustment Location X759-498...
- Page 6 Preset Potentiometer Supply (+) 1 PURPLE Focus Error 1 BLUE Figure 3 Circuit Diagrams Copyright 0 1998 Vicon Industries Inc. All rights Vicon and its logo are registered trademarks of reserved. Vicon Industries Inc. X759-498...
Need help?
Do you have a question about the V5.7-34.2AC and is the answer not in the manual?
Questions and answers