Chrono Graphs; Setting Time/Date After Battery Change; Basic Function - Invicta 360 Instruction Manual And Warranty

CHRONO GRAPHS

Setting the Time and Date . After a Battery Change
1. Pull out the crown to position 1. The watch continues to run.
2. Turn the crown until you reach yesterday's date. If you are setting the
date between 9pm and 12pm, the date must be set to the following day as
dates set between these hours do not automatically change at midnight.
3. Pull out the crown to position 2. To set the time to the exact second,
it must be pulled out when the second hand is in position 0. The watch
stops.
4. Turn the crown until you reach the correct date.
5. Continue to turn the crown until you reach the correct time.
6. Push the crown back into position 0. To set the time to the exact second,
it must be pushed back into position 0 at the exact second.
24
Before using the chronograph functions, please ensure that the crown is
in position 0 and the 4 chronograph hands are precisely at zero position
following activation of push-button B. Should this not be the case, the
positions of the hands must be adjusted.
1. Start: Press push-button A.
2. Stop: Press push-button A again and read the three chronograph hands.
3. Reset: Press push-button B. The chronograph hands will be reset to
their zero positions.
CHRONO GRAPHS
Basic Function . Start/Stop/Reset
25