Intermec AD8 Install Manual

AD8 Compliance Insert

For Users in the United States and Canada
Caution: This marking indicates that the user should read all included documentation before use.
Attention: Ce marquage indique que l'usager doit, avant l'utilisation, lire toute la documentation incluse.
Caution: For use with Intermec Models CN2 and CN2B. For power supply, use Intermec Model 074246. No user-
serviceable parts.
Attention: Pour utilisation avec les Intermec modèles CN2 et CN2B. Pour la source d'alimentation, utilisez Intermec
modèle 074246. Il ne contient aucune pièce réparable par l'utilisateur.
The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of
accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may
void the compliance of this product and may result in the loss of the user's authority to operate the equipment.

FCC Digital Emissions Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the radio or television receiving antenna.
• Increase the separation between the computer equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
• Consult the dealer or an experienced radio television technician for help.

Canadian Digital Apparatus Compliance

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Conformité aux normes canadiennes sur les appareils numériques
Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.

FCC Modem Compliance

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a
label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
• Equipment Manufacturer:
NetComm Limited
Unit 1, 2-6 Orion Rd.
Lane Cove NSW 2066
AUSTRALIA
• Model Number: IG1100
• FCC Registration Number: See identification number for modem marked on product label.
• Ringer Equivalency Number: See REN number marked on product label.
• Modular Jack (USOC): RJ11C
The Ringer Equivalence Number (REN) is used to determine the quantity of devices which may be connected to the telephone line.
Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs,
contact the local telephone company.
An FCC Part 68 compliant telephone line cord with modular plug is required to use this device. The modem is designed to connect to the
telephone network or premises wiring using a compatible modular jack that is also compliant. See installation instructions for details.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of
service may be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible.