Table of Contents
Advertisement
9. DETACHMENTS
9-1. Floor Console Exposed Type
WARNING
Be sure to turn off the power supply and the breaker
and then start a work.
No.
Spare parts
Electric parts
1. Detachment
assembly
(1) Remove the suction grilles (2 pieces).
(No screw fixing)
(2) Remove the wire guard.
(M4 screw: 4 pieces)
(3) Remove the front panel.
(M4 screw: 2 pieces)
(4) Remove the discharge grille.
(M4 x 0.8" (20L): 2 pieces)
(5) Remove the switch box.
(M4 screw: 3 pieces)
(6) Take off the fan motor lead from the clamp, slide
the glass tube, and then remove the relay connector.
(7) Take off the TA sensor from the clamp.
(8) Take off the connectors of TC1, TC2, and TCJ
sensors from P.C. board.
CN100...TC1 (3P: Brown)
CN101...TC2 (2P: Black)
CN102...TCJ (2P: Red)
* Unlock the lock of the housing part, and then
remove the connectors.
(9) Remove the relay connector of the PMV lead.
(10) Remove body of the electric parts assembly.
(M4 screw: 1)
2. Attachment
Following step 1 of
as original in the reverse procedure.
All manuals and user guides at all-guides.com
Be sure to put on the gloves at disassembling work;
otherwise an injury will be caused by a part, etc.
Work procedure
and (1) to (10), attach the parts
– 69 –
CAUTION
Remarks
Electric parts
TC1, TC2, TCJ
assembly
sensors
Clamp
Fan motor lead
TA sensor
Clamp
Relay
connector
(PMV lead)
M4 screw
Relay connector
(Fan motor lead)
Glass tube
Advertisement
Table of Contents
