Getting Started; Battery Removal And Installation - VTech DJ Beat Boxer Instruction Manual

GETTING STARTED

How to Exit Try-Me Mode
DJ Beat Boxer
Slide the Off/Low/High Volume Switch to the Off position to turn
the unit Off. Then, turn the unit On again to exit Try-Me mode.

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover on the back of the
unit, use a screwdriver to loosen the screw
and then open the battery box.
3. Remove old batteries by pulling up on one
end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
TM
is in Try-Me mode in the packaging.
of
children.
5