Faber INSM28GR250-B Installation Instructions; Use And Care Information page 9

Cleaning metal grease filters
The metal grease filters can be cleaned in hot detergent
(A in FIGURE
solution or washed in the dishwasher. They should be
• Remove grease filters.
cleaned every 2 months use, or more frequently if use
is particularly heavy.
• Remove the filter, pushing the lever towards the back
of the unit and at the same time pulling downward.
• Wash the filter without bending it, leave it to dry
thoroughly before replacing (if the surface of the filter
changes color over time, this will have absolutely no
effect on its efficiency).
• Screw the Frame into place
• Replace, taking care to ensure that the handle
faces forward.
• Cleaning in dishwasher may dull the finish of
the metal grease filter.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable
and cannot be regenerated, and must be
replaced approximately every 4 months of
operation, or more frequently with heavy usage.
• Remove the grease filters.
• Remove the saturated carbon filter.
• Fit the new filter by hooking it into its seating.
1/4"
• Replace the grease filters.
Replacing the bulbs
E-14 Base 28 W halogen.
• Remove the metal grease filters.
• Replace the bulb with a new one of the same
type.
• Replace the metal grease filters.
g the carton.
fixing pin lever.
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
EN
Drill Bit
-
Cabinet min
H=30"
cabinet
5" round
duct
inca smart
ceiling
A
c
5" round
duct
inca smart
9