Sleeve Installation - Wolf Steel DHMFG3850 Installation Manual

3.1

sleeve installation

1. Slide the sleeve into the framed opening from inside until the back side of the sleeve hits the vertical stud.
2. For front discharge: Install wood screws (quantities vary by model size) through the dimples along the top of
the sleeve [A] (see Fig. 1). Install 1 or 2 wood screws (varies by model size) through the hole(s) in the back of
the sleeve [B] (Fig. 2).
3. For side discharge: Install two wood screws through the dimples along the top of the sleeve [A], and one
wood screw through the hole in the back of the sleeve [B] (see Fig. 2). Repeat on opposite side.
Front discharge
Side discharge
note:
The front edge of the sleeve should stick out minimum 1/2" (12.7mm) from the framing. For installations with
thicker fi nishing material, see "sleeve extension installation" section.
(Fig. 1)
A
A
(Fig. 2)
B
A
A
A
A
A
B
rough framing
Type 3
W415-2968 / B / 04.30.21
EN
9