Start-Up & Operating Procedures - Pelsue Airpac15 Product Manual

5.2 - Start-Up & Operating Procedures
Prior to Operation, the Pelsue Airpac should be configured and prepared according to the following guidelines.
1. Pre-Operation Inspection:
It is necessary to perform a visual inspection, each time, prior to using the product. If deficiencies are found, remove the
product from service and contact the T.A. Pelsue regarding repair. The following checklist coupled with Figure #5.2a
should be used as a guide to determine whether the equipment is in good operating condition prior to usage. Equipment
that is not in good condition can endanger the safety of the entrant and attendant during use.
The Pre-Operation Visual Inspection is not limited to, but must include the following items;
a. Check the Airpac housing for any signs of damage.
b. All rivets are intact. The instructions plate is secured to the housing. The hose collar is firmly fixed to the housing.
c. The hose is secured to the hose collar.
d. Check to see that there are no breaks or bends in the helix wire of the hose and also the hose has no rips or tears.
Hose
Housing
Plate
Attach & Detach
Instructions
Hose Collar
Feet
Figure #5.2a: Pelsue Airpac
Pre-Operation Inspection Points
Page 12
#124313-001 - Product Manual: Model #Airpac15, 15-S, 25, 25-S - Revision 00 - Date: 05-18-2009